Farmall & IHC Tractors Discussion Board |
Update on Chevy intake leak
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul Shuler on February 03, 2006 at 14:50:24 from (170.29.248.3):
I have fixed my leak, or at least for now. Worked my hand in behind the head to see if I could feel where the water was coming from. I found a bolt that I couldn't even see that sat behind a lip on the intake and had the wireing harness laying on it. I had just enough room to squeeze a finger back there and found it only finger tight. After much work to get a wrench on it and turned it a turn and a half my leak for now any way is gone.No runs, no drips , no errors. Thank you all so much for you help on this problem. I think the intake bolts tend to get loose over time with the cast iron block cooling at one rate and the aluminum intake at another. Oh well,dry for now. Paul
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|