Farmall & IHC Tractors Discussion Board |
826D (D358) Oil Filter Question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jim Allen on February 02, 2006 at 07:02:09 from (209.173.160.22):
I have a persistent leak at my recently changed oil filter (using a Wix filter) on my fairly-new-to-me 826. What troubles me is that the surface upon which the oil filter seal rides has a deep groove. It looks like it was made there for an o-ring and the seal for the filter fits right in there.Is this groove a normal characteristic or should it be a flat surface? The old filter did not leak before (at least I don't think it did), but the housing did in a major way at the oil line o-rings, all of which which I replaced as well as the gasket where it mounts to the block. Can someone with D350 experience tell me what the oil fitler seal surface is suppose to look like? It could also be the filter, but it's hard to tell. I want to get back into the problem knowing what things are supposed to be like.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|