Farmall & IHC Tractors Discussion Board |
Re: Fire Crater pistons in M
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on January 24, 2006 at 12:53:07 from (66.228.96.216):
In Reply to: Re: Fire Crater pistons in M posted by randy hall on January 24, 2006 at 09:53:18:
I just went thru this,,, Had a M, put in a set of firecrater design pistons, (made for the late model heads) came from a late model tractor, used a 8060 head, and SLAP!! The pistons hit the head. Thats why the late model engines had the slant along the manifold side of the chamber, to make room for the new piston design. These were IH pistons, firecrater style pistons, in a M block with a 8060 head. I can show you a picture of them, the ones used inthe M, are totally different than the pistons used inthe 450. For one, the domes on the 450 pistons are spread out more over the top of the pistons,, onthe M design, they were a bigger dome, BUT, not spread out over the top of the piston. Which fit in the M heads,,, but not considered firecrater piston design. They were considered stepped head pistons. Big difference in the 2. SM-450 firecraters will not fit inside the M kerosine-gas heads, the M styles were stepped heads, even though they had a simular shape inthe dome, was much taller, and the dome is in one area of the pistons. Try this,, and its the exact same thing onthe SM,, put a H head on a Super H with firecraters,, Ill betcha a steak dinner, they will hit. Try the same with a SM with firecraters,, put on a M head, it will hit. Chad
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|