Farmall & IHC Tractors Discussion Board |
M running rough, need suggestions. Long.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by unioncreek on January 24, 2006 at 07:52:16 from (134.121.226.24):
My M has been running rough, found out two of the plugs were no good. So I replaced them and it ran good. Went to roll some grain on Saturday and I had to choke the heck out of it and it ran rough while rolling feed. I pulled the carb on Saturday and cleaned it good, didn't have a rebuild kit. All the holes are open, there wasn't any crude inside. I have the original bowl on it yet plus an inline filter. I have good flow from the tank to carb. I still need to choke it almost all the way and it will barely start. Will blow black smoke, but seems to even out now and runs good. But, I can shut it off and have to choke it again to start and it starts the same way. Any help appreciated. Bobg
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|