Farmall & IHC Tractors Discussion Board |
Re: 400 T/A questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by super99 on January 19, 2006 at 16:43:27 from (207.144.199.51):
In Reply to: 400 T/A questions posted by super99 on January 18, 2006 at 15:22:10:
I got it apart tonite. Soaked it overnite with good penetrating oil, still wouldn't move. Asked maintenence man at work, he said to give it a little heat, but not too much. Blew off asmuch oil as I could and heated with low flame till it started to smoke a little and tapped it with a brass punch and it came out. Ya, I was tapping on the cast fork, didn't think it was strong enough to tap on shaft and let cast ears take the pressure. Got the clutch out and the drive hub. Now have to make something to hold up case so I can split from trans to get to the rest of it. Thanks for the reply, will let you know what I find when I get it the rest of the way apart. Chris
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|