Farmall & IHC Tractors Discussion Board |
400 T/A questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by super99 on January 18, 2006 at 15:22:10 from (207.144.199.123):
I got the old girl split, throw out bearing and shaft came out easy, got the bearing and drive shaft out of front of t/a. Took set screw and lock nut off of t/a clutch shaft and snap ring off. I&T says pull shaft out and remove throw out bearing. It's stuck on shaft, tapped on it with a hammer and punch but won't move. Started to swell end of bearing carrier so I quit. Is there something else to take loose that I missed? Do I dare put some heat on it to loosen it? I do it to steel all the time but not sure about doing it to cast iron. Inside where t/a clutch is is pretty rusty, but the shaft isn't too bad, took emery cloth and shined up shaft. Any help would be great!!! Thanks in advance, Chris
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|