Farmall & IHC Tractors Discussion Board |
Re: input shaft supposed to have play?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by chadd on January 19, 2006 at 07:57:17 from (155.92.30.244):
In Reply to: input shaft supposed to have play? posted by Booe on January 19, 2006 at 06:11:38:
Do you mean the shaft itself has play on the transmission bearings, that the bolt has play in its hole in the yoke, or that the yoke itself has play? Technically, there really shouldn't be much play anywhere in there. The bolts should be tight in their holes in the yoke. And by tight I mean very tight!! After we got the nuts off of the bolts on our W6, we had to use long prybars and hammers to separate the coupler, as it did not want to come loose. If the shaft is wobbling, transmission bearings are weak and/or shot. If the coupler never gets tight, It is possible it is binding somewhere on the bolts or there is a burr in one of the bolt holes. We really had to crank on those bolts to get them to pull the coupler back together(because of the interference fit). We didn't have an impact so we did it with long breaker bars.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|