Farmall & IHC Tractors Discussion Board |
Re: Starting problems with 300
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 19, 2006 at 06:20:15 from (199.17.6.175):
In Reply to: Re: Starting problems with 300 posted by MagMan on January 18, 2006 at 18:18:17:
If you have a ballast resistor, and a 12v no resistor required coil, the symptom will happen. If the starting wiring is missing the bypass (from the solenoid "I" terminal to the coil side of the resistor, that is the problem. If the starter is drawing excessive current, that is the problem. Starter draw (measured with a cheap hold against the wire gauge) should be about 250-350 amps warm 6volt or 200-300 range 12 volt (if cold ~freezing the current can double). JimN
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|