|
Farmall & IHC Tractors Discussion Board |
Re: She is NOT getting the better of me today.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on January 16, 2006 at 17:00:55 from (4.124.76.207):
In Reply to: Re: She is NOT getting the better of me today. posted by MN Scott on January 16, 2006 at 16:48:53:
A block of wood and a hammer is not what i call a press fit , there was some talk about this from Clevit and the one Clevit guy said that a hand fit was good well he was wrong . As these sleeves are to be pressed in at a give pressure on the OTC doubel piston hdy puller . and at the moment i don't have the spec . setting here and off the top of my head it is somewhere around 3to7 ton that they should be pressed in as they say for proper thremeral exchange .Now in the years that i worked on them i have seen encluding my owen experance a total of 6 that have sucked the sleeve one 560 several 460's a 656 gasser and one diesel and 706's all shortly after overhaul.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
