Farmall & IHC Tractors Discussion Board |
Re: She is NOT getting the better of me today.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MN Scott on January 16, 2006 at 16:48:53 from (206.9.216.92):
In Reply to: Re: She is NOT getting the better of me today. posted by Kelly C on January 16, 2006 at 15:25:18:
Boy I don't know, the sleeve I just replaced in my 263 706 was a D class bore and the new sleeve took a hammer and block of wood to install it. Every thing was perfectally clean and the bore measured in specs, no taper or eggshaping. Not hard pounding but defenially not hand fit. The sleeve was from A&I and was USA made. Some new sleeves have variations in them so if one fits loose try another one, same goes for the pistons. Then you can always cheat and install the sleeve permanatlly with iodine. Make sure the sleeve and bore are cleaned with brake clean, then coat the sleeve and block bore with iodine making sure not to get it in any part you dont want rusted. Install the sleeve and leave it 48 hours and it will be permanatlly rusted in. I would'nt recommend it but thats the way the old timers around here used to do it.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|