Farmall & IHC Tractors Discussion Board |
Re: Stuck switchover gas/diesel
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by BIG JOHN on January 15, 2006 at 16:37:38 from (207.200.116.5):
In Reply to: Stuck switchover gas/diesel posted by WV on January 15, 2006 at 16:19:41:
The change over linkage goes down the left side of the tractor to the center of the block at that point the linkage goes thru the block to the right side. At that point on the right side you will find where the linkage attaches with the gasoline carb & manifold. There is a spring about 1" long that makes this all work. Sometimes they break or just loose their tenstion. This spring is really pricey from IHC but one off the shelf at the Hardware store will work just fine. Less than $2.00. GOOD LUCK
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|