Farmall & IHC Tractors Discussion Board |
Re: IH/Farmall 706 Range Arm Removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by William Thompson on January 09, 2006 at 10:12:46 from (68.253.117.246):
In Reply to: IH/Farmall 706 Range Arm Removal posted by William Thompson on January 08, 2006 at 16:49:51:
Tractor Vet: Thank you for the response. Yes, it is the levers on the right side of the steering tower. I understand how to get the cover off (remove long screw and bolt). Then,remove the cross bolt holding the outer arm (gear lever), and remove outer arm. Now this is where I'm stumped. Is the inner arm or range lever pressed on to that shaft. You talk about a bushing that was bad, and a bushing bore that you had to re-machine for a new bushing. Is that arm supposed to slide off the shaft or is it retained in some other manner?
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|