Farmall & IHC Tractors Discussion Board |
Re: splitting a 400
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Kelly C on January 01, 2006 at 10:07:19 from (63.171.43.140):
In Reply to: splitting a 400 posted by super99 on January 01, 2006 at 07:31:09:
This works good for the front. Just take 2 lenths of angle iron, cut 2 or 3 inches off the bottom. Weld that into a square at the bottom. Cut the right size square for the bottom plate. Drill 3/4 inch hole in the center. Weld a 3/4 inch nut over the hole. Thread 3/4 rod into that/ with a 3/4 inch nut welded to the bottom of the rod. Makes it adjustable. Use a 5 ton jack on the rear to split. I also used 3/4 rod to keep the halfs aligned to do clutch.
I tried the cherry picker on the front and that turns into a mess. It will pivot on the wheels and get out of alighnment.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|