Farmall & IHC Tractors Discussion Board |
Re: 1951MD
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on December 30, 2005 at 19:27:41 from (12.65.6.21):
In Reply to: 1951MD posted by Farmall Wrangler on December 30, 2005 at 16:30:54:
All of the MDs were 12 volt from the factory. They had two 6 volt batteries connected in series. One battery under the fuel tank like the gas M and the second one beside the seat support on the right hand side. The seat support had a cutout in it to accomodate the battery box. Later MDs may have had the under seat battery box like the supem Ms. But as far as I know no MDs were 6 volt systems. The generator setup with the casting support sounds like the original setup. The factory 2 speed and the disk brakes are not factory, but aftermarket add ons. The "2 speed" is probably an M&W 9 speed setup which gives 2 speeds in each of gears 1 through 4. This setup makes the PTO run faster than standard in high range. The disk brakes are likely the Lambert after market brakes. These are similar to but different than the brakes on the super series. They have 3 bolts holding the castings to the transmission housing instead of 5 as the supers do.
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|