Farmall & IHC Tractors Discussion Board |
Re: speed sleeve for an h axle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on December 25, 2005 at 18:11:28 from (12.65.12.193):
In Reply to: speed sleeve for an h axle posted by tn terry t on December 24, 2005 at 21:17:04:
I've used the speedy sleeves a couple of times with very good results. However, I wonder about being able to slide one all the way over the axle of an H up to where it needs to be. You sure are going to have to clean that axle up all the way, getting every nick smooth and then make yourself a tool to install the sleeve, as the one that comes with the Speedy Sleeve is very short, intended for use on the end of a shaft. I used a piece of PVC pipe for the one I put on a C main steering shaft, but that was a short distance compared to an H axle. I have also always put the shaft in the freezer to shrink it to make installation easier. You'll need a good sized freezer for the H axle. If you can get the sleeve on there though it will do a good job for you. Be sure to give us a report if you do this, as I'm very curious to know if you can slip one of those sleeves on that far.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|