Farmall & IHC Tractors Discussion Board |
Re: replace and tighten fan belt Farmall H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by P Backus on December 15, 2005 at 08:31:10 from (69.128.32.197):
In Reply to: replace and tighten fan belt Farmall H posted by delbert doty on December 15, 2005 at 07:48:29:
Actually the H does have a tensioning device, but it"s not what you"d think. The pulley on the fan is threaded. There is a set screw that holds it in place. Loosen that and the front half of the sheeve will unscrew toward the fan, allowing you to get the old belt off, new belt on. Sometimes you have to tap it with a punch on the flat spots on the hub to get it to move. Then tighten it by screwing the sheeves together, making the belt ride higher on the pulley. You never get it really tight like in a car, etc., but that"s okay. It sounds to me like your regulator is stuck, causing the generator to motor. When the engine is shut down, the contacts in the regulator should open. Paul
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|