Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Man o Man You shouldv'e seen the A Plow Snow!


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by Hugh MacKay on December 13, 2005 at 12:47:33 from (209.226.106.107):

In Reply to: Man o Man You shouldv'e seen the A Plow Snow! posted by Farmallkid From Ont, on December 12, 2005 at 14:21:52:

Mitch: So you just found out another one of life's little secrets. Pound for pound that little offset is the best tractor IH ever built. Doesn't matter whether it be A, SA, 100, 130 or 140, given their own weight they make their big brothers look very ordinary.

I'll throw you another idea for next summer. Find a sheet of 1/2" steel 4' x 10'. Turn about 5" up 45 degrees at each end. Weld heavy angle iron along each side on the up side. Hook a heavy 4' chain to each end. Now your in business for a real farm situation tractor pull. None of this whimpy stuff of starting with a load that gets heavier as you go. In a real farm situation you start with a full load and go. No classes in this pull, Farmall A competes against the mighty M. The winner is the tractor starting away with and pulling 10' the highest percentage of its own weight. Pullers can add weight to their tractors as they see fit. Adding weight gives no real advantage. Often time it hinders.

It doesn't matter whether these are regular letter series or supers, the A will be the tractor to beat. It will cause the others a lot of grief. Operator skill is very important. I've seen 3 guys pull the same tractor and not place in sequence. I've also seen the same guy win with any of these tractors. If I were to enter one of these pulls, my pick would be A or SA. It has the best chance of pulling over 3 times it's own weight. I've seen a lot of these type pulls and from what I've seen would rank A - 1st, H - 2nd, M - 3rd and C - 4th.


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy