|
Farmall & IHC Tractors Discussion Board |
Re: 450 to 560 wheel exchange
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on December 07, 2005 at 13:37:09 from (209.226.106.34):
In Reply to: Re: 450 to 560 wheel exchange posted by CNKS on December 07, 2005 at 11:39:27:
CNKS: My 560 had one keyway. I purchased a set of SM wheels for duals. All I had to do was change the cast clamps to clamps without key in them. Keyway on other side matched. I know of a situation whereby they ground keys out of clamp. I'm wondering if two keyways didn't actually weaken the axle. When new our 300 came with wheels dished in but out to end of axle. The first week my dad had the tractor when new it sheared the keys out of one wheel. The dealer fixed this by having a matching keyway cut in wheel, then installed a key to fill both axle and wheel keyway. They never did replace keys on clamp. I urged my dad to change wheels so dished out at the time. I was only 13 at the time and who listens to a 13 year old. IH dealer was right in dad's opinion. About 10 years later I was moving a building on skids, pulling with both 300 and 560. I put Canadian Ring Chains on 300 for better traction. When we were done I noticed the 300 had close to a 1/4 twist on one axle. While still straight and rigid it was split along bottom of keyways on both sides. I bought a parts tractor that had been in a fire and changed the axle. Changed wheels to dish out also. By the way that wheel with keyway cut in cast and large key to fill both keyways was on the 300 for at least 35 years, probably still there as tractor is still going.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
