Farmall & IHC Tractors Discussion Board |
Re: How much is it to refinish the crankshaft main
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by El Toro on December 06, 2005 at 10:18:34 from (205.188.117.73):
In Reply to: How much is it to refinish the crankshaft mains? posted by AndyE. on December 06, 2005 at 10:00:21:
If they don't look the best you should use a micrometer or have your local machine shop to measure the rod journals. This way they can determine if the crankshaft is egg-shaped and would require it to be ground undersize if it is. The mains may need to ground too. Your local auto machine shop can quote an estimate by phone if rod jouranls and mains need to be ground. They may be able to just polish the shaft and it isn't scored very much. If it's worn .002" under specs you could use .002" undersize bearings on rod and mains. I think some places even have .003" undersize bearings. Hal
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|