Farmall & IHC Tractors Discussion Board |
Re: H and M heighth
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on December 05, 2005 at 18:12:00 from (204.249.178.138):
In Reply to: Re: H and M heighth posted by Nebraska Kirk on December 04, 2005 at 15:21:25:
My M book says 78 1/4, my H book says 75 5/8. 2 5/8 difference. My Operator's manuals are the latest verisons. Differences could be what IH was calling the standard tires at the time -- earliest ones were on 36 inch rims, the manual for my dad's 1941? H listed dimensions with steel wheels, if I remember right. Current manuals list the H with 10-38, M with 11-38, thus a slight diameter difference. If equipped with 4 ply tires they will sit lower than with 6 ply (I don't consider 4 ply a good idea on an H or M). Perhaps we should just say there isn't much difference.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|