Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Electronic Ignition? What do you think?


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by John T on November 22, 2005 at 10:31:50 from (66.244.90.98):

In Reply to: Electronic Ignition? What do you think? posted by Farmallkid From Ont, on November 22, 2005 at 08:19:35:

Kid, Once you overcome the initial cost, an electronic current switch is far superior to the old fashioned mechanical points current switching and energy absorbing protective condensor for numerous reasons. For one, soon as you use the points they begin to deteriorate from the constant arcing across their surfaces which burns, carbons and pits the surfaces and increases the resistance across what should ideally be near a zero ohm circuit path. Energy wasted across a resistive connection would be better spent discharged across the spark plug gap to ignite the fuel. Also, you have the wear factor on the cam follower causing their gap to change. Also, they are not that good of a switch as they bounce n ring. Another factor is possible longer plug life if a performance coil and a wider plug gap can reduce fouling deposits from accumulating so badly.

To the contrary, an electronic switch provides a faster and more positive switching for the coils current as opposed to the bouncing ringing points. Better switching improves coil efficiency as far as its mutual inductive coupling transformer action is concerned. The electronic switch does not deteriorate due to carbon or pitting or burning either.

Another advantage of the elec switch is if you couple it with a high energy high voltage coil which allows you to get more bang for the buck and utilize the full potential an elec. switch can provide. Theres still advantages even with the stock coil due to the faster more positive switching, but couple it with a high energy high voltage coil and you have the ability to discharge more energy across a potentially wider plug gap to ignite the fuel.

A disadvantage may be that with points one may be able to file or dress the points in the field to get back to the barn, but if an elec. switch fails your dead lol.

I guess the elec switch costs about 4 times a set of points n condensor BUTTTTTTTT it should last wayyyyyyyy longer then several sets of points and its NOT deterioratign the moment you use it.

Be sure to get a switch that matches your polarity and be sure the switch is matched n suited for the coil you purchase and I run a lil wider plug gap on an elec ignition.

John T, retired electrical engineer and believer in an elec ignition.


Follow Ups:




Post a Followup

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy