Farmall & IHC Tractors Discussion Board |
Re: Schrader valve
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on November 12, 2005 at 05:34:29 from (24.235.41.226):
In Reply to: Schrader valve posted by Muley on November 12, 2005 at 03:06:35:
I changed the core valve on a tractor tire last week. I went to put air in it and it had turned green and corroded so badly there was nothing left to get a hold of to just change the valve. The tire was loaded so I set it with the valve at the top..should have then jacked the tractor up, but didn't ,turned the core out, put my thumb over the tube valve and then quickly jammed the new one in and turned it tight..maybe lost a few quarts of fluid, job done! As UNCLE says the tube valve will be held in place by a plastic nut so you shouldn't need to worry about the tube popping back into the tire. Make sure the replacement core is the right one. There are two types which the tire dealer refers to as the "old style" vs. "new style' Not to worry as the old style were for tractors such as 2N, 8N Fords. Good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|