Farmall & IHC Tractors Discussion Board |
Re: H with a crack!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on November 08, 2005 at 11:42:43 from (199.17.6.175):
In Reply to: Re: H with a crack! posted by Tallperson on November 08, 2005 at 04:37:07:
The fact that the crack stopped at the clutch shaft is proof of the hole in the end of the crack stopping the progress, being true. I welded a football size chunk back into a Ford 4000 tranny where the single arm loader mounts. (a friends son was rototilling and failed to make the headland turn at 15 mph. the bucket hit a concrete feed bunker in the tall stuff and the arm snatched a big wad of cast with it. I deep "V"ed the joint and used nickel rod with DCRP to fill the "V". after grinding and painting it was invisible. The loader was bolted back on and is still working! To look at one that is broken, check out the picture in the thread (might be page two or three by now on splitting an H. JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|