Farmall & IHC Tractors Discussion Board |
Re: Hey Slappy How Did Yor rebuild turn out?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MagMan on November 03, 2005 at 16:45:30 from (64.12.117.13):
In Reply to: Re: Hey Slappy How Did Yor rebuild turn out? posted by Slappy on November 03, 2005 at 15:42:58:
Well that big carb looks a little out of place. The manifold is pretty close to the same except for made for the bigger carb the SH had them so I guess thats what I kind of have is a stock SH with a little more head work. I also reworked the Gov myself just to make sure everything was tight and all the holes were round and not oblong but I have reved her up to about 900 rpms so far and that about it. Becuase of not having any water in her yet. I am going to have to post on the pulling board to see what the best way to break this beast in would be. Let me know when you will be leaving for your trips. It seemed like you were gone a long time the last time. Do I owe you anything for that Mag or Shipping? JON
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|