Farmall & IHC Tractors Discussion Board |
Re: H Motor Stuck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. on October 30, 2005 at 16:21:30 from (65.161.170.79):
In Reply to: H Motor Stuck posted by Tweeter on October 30, 2005 at 14:55:26:
Tweeter, First remove the gas tank, roll the tractor out of the shop. Keep all flamable liquids away!. Now one at a time pour diesel into the cylinders and set fire to the diesel. Let it burn itself out....Then drive out the piston. The heat from the fire will break the rust, expand the cylinder from the piston,and make it more easy to get apart. You will still be able to reuse the parts unless there are toooo much rust pits. or unless the rings are rusted up solid. The acetylene will heat it all up but be careful not to melt the metal if you plan to reuse the pistons and cylinders. Hope this helps. Later, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|