Farmall & IHC Tractors Discussion Board |
Re: For Magman clutch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MagMan on October 30, 2005 at 11:39:28 from (64.12.117.13):
In Reply to: For Magman clutch posted by Janicholson on October 30, 2005 at 09:42:41:
Man I hope I got that darn thing in right. All the rest of the ones I have, have a oil slinger Cup on them that goes toward the FW Otherwise there is not much different in the clutch. Well the New one I looked at it and seen where the rivits were higher on one side and desided that was the way the others were without the slinger on them This clutch does not have springs or anything just a plate with the center rivited for the shaft on it. So I am 99% sure its right and the fingers are adjusted almost all the way out cant go much farther. Oh well I splashed some paint and lady bugs on the motor today its a balmy 60 deg here today beautyfull day. Hopefull before the weeks out I will get her fired up and see how she does. Were you the one that recomended something for puting in the cylinders and if yes where would I get it.? THANKS FOR ALL THE HELP jon
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|