Farmall & IHC Tractors Discussion Board |
Re: 656 remote leak
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by K.B.-826 on October 25, 2005 at 16:19:12 from (66.188.223.190):
In Reply to: Re: 656 remote leak posted by PennsMike on October 25, 2005 at 09:15:02:
In addition to the three o-rings you disturb during disassembly, to stop the leak you replace the detent piston and it"s o-ring. Reason for this is because the o-ring is very difficult to install onto the piston without wrecking it, so Case-IH sells the piston and o-ring as an assembly. You can save a couple $ and try relacing just the o-ring, but you"ll be back in there again soon. No, this does not have anything to do with lifting power. When you"ve got the lever latched in either the forward or rear position, the detent piston is what unlatches the detent and causes the lever to return to the middle position when the pressure you"ve got it adjusted for is reached. I would use a 5000 psi guage to be safe, depending on what"s been done to it, a 656 could develop 2500 psi easy.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|