Farmall & IHC Tractors Discussion Board |
Re: 806 Range Gears
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AGR538 on October 13, 2005 at 07:05:44 from (65.114.61.232):
In Reply to: 806 Range Gears posted by Rocko1 on October 12, 2005 at 19:42:16:
I cannot believe it would be those two parts keeping it from going into high range without those parts being visibly broken. I am assuming you have taken the top inspection plate off and can look down into the transmission. Make sure the little bolt holding the shifter fork onto the slide bar going across the top left side of trans has not broke. Sometimes the slide bar breaks in half also. I agree with the other post. The holes in the top of that inspection plate get wallowed out and have enough play to keep it from going into gear. You can buy reconditioned plates with bushings pressed in for about $150. If you have that inspection plate off, you should be able to take your hands and shift it in and out of any range. The reverse is shifted on a gear in the left side down at the bottom. I may be telling you alot you already know so I do not mean to sound too elementary. However, I appreciate people who reply to my questions keeping it simple just in case I missed something.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|