Farmall & IHC Tractors Discussion Board |
Re: M rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DWV on October 08, 2005 at 05:30:30 from (64.12.117.13):
In Reply to: M rebuild posted by Poorboy on October 07, 2005 at 20:36:01:
Use main and rod bearings to fit the 450 crank and it works with no problem.The 450 rods are same length as M but have a smaller wrist pin hole.M rods will work with 450 crank.Whichever rods you use the piston and pins need to match. The 4-1/8 inch 450 pistons go in M block if not using sleeves.4 inch and sleeve is biggest in M block without machine work.IH used to make fire crator piston sleeve sets 4 inch bore with small wrist pin like the 450 rod.Don't know if anyone still makes them that way or not.450 gas head and cam will increase power of the M.Also adapter wrist pin bushings available so the pistons out of the M could be small pin.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|