Farmall & IHC Tractors Discussion Board |
Re: M rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jason Simmerman on October 07, 2005 at 22:14:19 from (70.106.35.18):
In Reply to: M rebuild posted by Poorboy on October 07, 2005 at 20:36:01:
Not sure about this but from external observations it should work with some machine work. You might need to have the block line bored to accept the 450 crank but I doubt this. It looks like the parts catalog on here calls for the same bearings for a M and a 450 so you might be ok there. Gotta check everything and see. You also might need to install a super M sleeve kit if not a 450 sleeve kit. You might not need to eithor. The reason you might is because I'm uncertain if the crank stroke is the same on a M as it is on a 450. If the stroke is bigger on a 450, the connecting rod might strike the sleeve wall. Also have to take into account connecting rods and pistons. It will be a simple swap over as long as you ensure you have compatable parts installed in the engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|