Farmall & IHC Tractors Discussion Board |
Re: F-20 Rear Axle
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Walt in Jaxn Tn. on September 16, 2005 at 22:27:30 from (24.176.117.211):
In Reply to: F-20 Rear Axle posted by Dave S on September 16, 2005 at 20:34:02:
There are two, one to keep the grease in the transmission/rearend in it's place and one behind the brake assembly to keep the grease in the bull gear housing in it's place. The one behind the wheel hub is to keep dust out of the outer cage bearing. I'd remove the fill (over flow) plug on the side of the bull gear housing (not the drain plug on the bottom) and let the grease flow down a clean path into a clean container till it stops and put it back in the transmission. You will find that when you keep the bull gear housings from over filling, you will not have as much problem with grease leaking out the axel shaft seal, also, give the zerke fitting in the middle of the wheel (on the out side) a couple shots of gun grease from time to time, that is what lubricates the cage bearing. --Walt--
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|