Farmall & IHC Tractors Discussion Board |
Re: super m 1952
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on September 16, 2005 at 09:35:21 from (199.17.6.175):
In Reply to: Re: super m 1952 posted by El Toro on September 16, 2005 at 08:33:01:
The coolant side of the new sleeve is where I have issues with a cracked dry sleeve block. If the original block cylinder is machined away entirly, there will be no structural support on the deck, or lower block from the column strength of the casting. I can't imagine a good seal on the lower end either. If the block is bored only to take a thinner sleeve, then relined with a real dry sleeve, my feeling is that the crack has not been stopped, nor is cooling even at the crack, and the corrosion in the crack could spread farther around the cylinder, and or leak into the oil side of things. My opinion is that the only engine worth salvaging with desperate measures is a one off unique engine with extreem rarity. I'd Find a good one before spending $ on something to worry about (even if it never goes bad). JimN
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|