Farmall & IHC Tractors Discussion Board |
Re: Why Pos Ground
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John T on August 11, 2005 at 06:26:36 from (66.244.90.73):
In Reply to: Re: Why Pos Ground posted by Dellbertt on August 11, 2005 at 06:16:55:
Good point Dellbert, back at Purdue many moons ago we used the conventions of Conventional Current flowed from Pos to Neg (like outside the battery) while Electron Current (like inside the battery) flowed Neg to Pos. I tried to teach my kids when they studied science theres no such thing as voltage on a single point theres a voltage potential difference BETWEEN TWO POINTS and its between them current seeks a path to flow. The higher the voltage the worse the curent really wants to flow. I certainly agree the tractor DC starters turn the same direction regardless of polarity cuz youre not reversing the relative N/S polarities of the Field versus the Armature. However in those light cheap low torque permanent magnet motors (dont use a current induced electromagnetic Field) if polarity were reversed they indeded would run bass ackwards. I love this sparky chat John T
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|