Farmall & IHC Tractors Discussion Board |
Re: ahha B250 brake stack height
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on July 28, 2005 at 16:38:30 from (209.226.106.147):
In Reply to: Re: ahha B250 brake stack height posted by oldtime on July 28, 2005 at 02:00:53:
oldtime: That is what I figured you were talking about. You've completely rebuilt those brakes using new discs and they don't grab well. Do the pedals have adjustment bolts. Most of the old American built Farmalls had this, however I've seen a few British tractors without the adjustment. The 656 Farmall for example used shims under brake cover when tractor was new and you removed these as needed. This worked much the same as machining you describe. Another thing we often had to do with new brake discs was rough them a bit with a sander or rasp. Some of them had such a hard glaze on them from factory you couldn't get them to grab. These brakes don't have a reputation of being best in the world by a long shot.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|