Farmall & IHC Tractors Discussion Board |
Re: Howard gear reducer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Janicholson on July 16, 2005 at 17:35:40 from (66.173.50.87):
In Reply to: Howard gear reducer posted by Joy McDonald on July 15, 2005 at 12:27:33:
anything is possible!! with that said, I have adapted several medium HP (100-200) drive lines with intermediate boxes to add lower gearing. The unit you have? has a relitively small torque tube (middle cast iron case) with a shaft in it. Fitting a small profile gear box in it may pose a challenge. Some things to remember: Using an auto gear box with a short tailshaft housing (like a early 60s chevy three speed) will definately handle the power. And second, Drive shaft linearity is mandatory. Third, Shifting with Push pull acbles is easy to install. forth: Anchoring the "Box" to the tractor frame/torque tube is manditory to absorbe gearing forces. fifth: Using the input shaft from the other trans in the IH clutch will require a different driven disk. And last, do not cut into the casting of the Farmall (except for mounting holes). Big material removal will be instant break in half business. Good luck! A cheaper (far easier) way to go may be a hydro based unit. Good engineering. Jim Nicholson
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|