Farmall & IHC Tractors Discussion Board |
Re: '48 Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Calif. Farmall on July 08, 2005 at 02:10:13 from (207.200.116.203):
In Reply to: '48 Super A posted by Tom Keena on July 07, 2005 at 20:09:45:
The stock carb is fine, my 46 A has never had a problem in the 30yrs we owned it untill I took it apart and put the needle in upside down. WOW and I do this stuff for a living on cars, did I ever feel stupid! You may have a bad Float or it set wrong. If you take the carb apart, put the needle in pointed end up. There is also a little plunger in the bottom of the needle that can fall out with a tiny spring, so make sure it's there. Turn the carb top upside down and the float resting with it's own weight pushing on the needle. The gap from the float to the body is 9/32" or if you just make it level it will come out real close. If your not sure your float is good buy a new one and a new needle from this web site it's much less hassel than pulling all your hair out and the girls all laugh at you!!!! If you still can't figure it out email me at hotwrench81@yahoo.com Happy tractoring DAN.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|