Farmall & IHC Tractors Discussion Board |
Re: 3 pt conversion?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger WI on July 05, 2005 at 19:41:16 from (69.58.150.228):
In Reply to: 3 pt conversion? posted by Thack on July 03, 2005 at 21:53:31:
I have a two bottom plow on my Super H with a 3 pt conversion. As the others said, it works OK on flat ground, but any unevenness in the ground and the plow either goes in too deep or comes out of the ground. I use mine mostly for plowing gardens as it is good to manuver on small gardens. The problem I have is at the end of the garden as the rear wheel comes out of the furrow then the plow comes out unless I push the hydraulic leaver all the way in. Also on my garden the ground drops off at the end, so I again have to lower the plow at the end. I have similar problems with my Woods brush cutter mower and my 3 pt rototiller (except the rototiller has skid plates on the side to control depth). All in all the 3 pt works, but not up to standards of tractors with factory made ones. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|