Farmall & IHC Tractors Discussion Board |
Re: what head work is needed when ringing M???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dej(JED) on June 30, 2005 at 10:00:06 from (66.212.143.210):
In Reply to: what head work is needed when ringing M??? posted by scruffyia on June 30, 2005 at 09:04:44:
I would pull the head with manifold attached. The head probably won't need plained and if you haven't been losing power you probably don't need the valves redone. There are a lot of guys who are going to argue that one though. You can take the head to an auto parts store and have them redo the head and valves. The valves will probably be well worn and they will try to have you replace them and the valve guides. If when you look at the head from the valve side and you don't see any black spot or obvious burn marks, I wouldn't bother redoing it. Remember all we want to dohere is stop the oil burn and pep her up a little, correct? I have reused head gaskets with a high temp sealer and added a couple of extra psi torque to teh spec. Also on an M you don't need to split it to do teh clutch. That is a simple job through teh bottom where the belley pump is fitte din.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|