Farmall & IHC Tractors Discussion Board |
Re: super m carb serial number
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmall on June 13, 2005 at 22:25:50 from (66.186.75.75):
In Reply to: Re: super m carb serial number posted by ChadS on June 13, 2005 at 09:01:22:
The super mta I just drilled the hole 2 sizes bigger and the plugs are really fowling, I can turn the jet screw in and the black smoke will be reuced but when I give it a shot of gas there isen't enough. You said something about the coil. I have a original style but new 6 volt coil, do I need to change it? When I put new plugs in the tractor runs like a million bucks but when it idless before it pulls it starts alot of black smoke and then it won't run worth a darn. I was just going to go back to a stock carb but it sounds like I wouldn't be using the money I already spent in the engine to its upmost potential which was my original goal. Now super h time, I put the spring in and the rpms are now plentyful. I checked the plugs after the pull and they were light black, so I'm asuming that it is getting more than enough gas. Is there anything else I should be donig to this tractor (timing) or am I close to the end. That govenor spring brought the life back to that super h. Its revs so hight that I can't get the idle down to a low idle, but that doesn,t worry me at all. Thank-you for your help it is greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|