Farmall & IHC Tractors Discussion Board |
Re: 140 Lift
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 10, 2005 at 03:47:29 from (216.208.58.170):
In Reply to: 140 Lift posted by Avery on June 09, 2005 at 04:33:37:
Avery: Upon reading Jim Becker's post, I reread yours again. I think Jim may have nailed the real problem, that is if lever is following the hitch to downward position. I replaced those friction pads in my tractors some years ago. What in fact my 130 does, is implement will settle couple of inches then system will fetch it back up to the preset lever position, without touching lever. Sorry if I may have mis led you. Two separate problems, two separate solutions. Another problem I had when friction pads were in poor condition, I would lower an implement to say for example 1/2 way on lever. When hydraulics completed that pre selected stroke, lever would continue to move on it's own all the way to bottom, thus hydraulic function would do the same. Also those friction pads are spring loaded, and with rust built up the sleeve around lever shaft can pivot with lever rather than lever shaft pivoting within the sleeve. I remember when I fixed my tractors I bought enough springs and friction pads for both tractors. I still have two friction pads on hand. Cleaning and lubrication cured those two.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|