Farmall & IHC Tractors Discussion Board |
Re: IH 454 trouble
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on May 28, 2005 at 16:36:34 from (69.196.154.214):
In Reply to: Re: IH 454 trouble posted by joe/pa on May 28, 2005 at 13:22:20:
Hi Joe, If it was a siezed pilot bearing, the tractor would keep on going when the clutch was depressed. The IPTO shaft is hollow and it is driven from the pressure plate and always turns with the engine and in front of the speed transmission, it is then geared to another shaft that drives hydraulic pump and is input side of IPTO clutch. The transmission input shaft is connected to the clutch and runs down the center of the IPTO shaft into the speed transmission. I would go with Bernard's diagnosis as the problem is in the speed transmission. Bernard has lots of experience on these tractors as the same transmission rear end is used in 454,484,485,495,464,574,585,595,674,684,695,784, 884,895 series tractors. JB2
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|