Farmall & IHC Tractors Discussion Board |
Re: bleeder screws on a 454 ??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmallkid1958 on May 20, 2005 at 18:56:26 from (216.21.191.190):
In Reply to: bleeder screws on a 454 ?? posted by pat,maplehillfrm on May 19, 2005 at 20:26:21:
We had a 584 which was the next generation newer of tractors. the bleeder valve for the brakes was just about 1 inch or so above where the rear axel housing bolts to the rearend housing. it looks like a bleeder on a car or truck. its not very handy to get to, and it might be covered with dirt and you might not be able to see it. but with the tractor running crack it open and bleed it like you would bleed a car. open the bleeder then press the pedel down and then close before releasing the pedel. repeat untill all air is out. hope this is of some help to you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|