Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Dang those Champion Plugs


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by kfox on May 17, 2005 at 20:35:40 from (63.18.231.231):

I put my liftall pump back in the H today and got ready to test it. When I pulled back on the lever, the engine was missing. Couldn't hear it when it wasn't under load, but the pump was working really good, and it loaded the engine down a little. I noticed a little bit of a miss the last time I had it running, but the miss went away after a few minutes. I pulled the spark plug wires one at a time, and # 4 was missing. I had plenty of spark from the wire, so I guessed I had a valve sticking. I put a new set of plugs in the tractor the day I brought it home last year, and They probably haven't been run 10 hours since new so I didn't think it could be the plug. I deciced to check the valves, since I've never done anything to the engione except the pulugs & oil change. The valves were badly out of adjustment-intakes way to tight& exhaust too loose. Had to take my new alternator off to get the valve cover off, so it was a afternoon job. When I got it back togather & started again, Still had the miss, but only part of the time. Let it run about 45 min, and it didn't get any better so I switched #4 plug with #3. Arrrrgh, now #3 was missing. Unscrewed the plug and grounded it with the wire still on. It only fired about one time out of ten. Dang them Champions. Found one of the old ones that I took out last year and cleaned it up And she runs good as new. Going to town to get a new set of some other kind of plugs, tomorrow. I didn't know if the liftall pump had been upgraded, or not, because there wasn't any yellow # 8 on the tank. I found out when I pulled the handle back-my 5000# gague went almost to 1000#. Probably because I put a thin stainless steel washer under the relief valve spring. Probably shouldn't have.
ken


Follow Ups:




Post a Followup

:
:
:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy