Farmall & IHC Tractors Discussion Board |
450 gas stuck engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Billy D on May 16, 2005 at 16:49:36 from (64.12.117.13):
Just bought a farmall 450 for 1,400 dollars, Good buy but found out from the owner that the motor was slightly stuck meaning that this happened to him before and he just poured in a little diesel fuel and loosened it up before. I bought it cause I was told not to let a deal like that get past me but after soaking the pistons with pb blaster and then with tranny fluid I still can"t get it to move. I took the oil pan off and felt up into the sleeves and the only ones with a little scaley rust are the two middle pistons. The rust is only on one side of the sleeves. Is there anything I can do short of pulling off the head and beating on the pistons with a block of wood and sledge hammer. I need help. Also the motor has freshly been rebuilt and is nice and clean except for this problem. Thanks for your help
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|