Farmall & IHC Tractors Discussion Board |
Re: hints on pulling w/ Super M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on May 06, 2005 at 07:24:38 from (66.228.96.156):
In Reply to: Re: hints on pulling w/ Super M posted by RustyFarmall on May 06, 2005 at 06:41:08:
Id say, if it is your first time, have fun, and be safe. Get a feel for what the tractor is going to do on the track. Expect the unexpected, front end being too light can overturn, and thats something you never wanna see. keep the front weighted down pretty well, till you get used to it. then get a little braver and let the front off the ground a bit more as time goes by. Super M's are great low gear pullers, lots more torque over a stock M so it will have pull if the carb is right. Pu on wheelie bars and practice this sport carefully, and have a ball! With your old Farmall! let us know how you did! Got all sorts of info on how to hop it up a bit more if it needs more power,, thats a different story at the moment for your tractor and experience. Hope this helps,, Chads
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|