Farmall & IHC Tractors Discussion Board |
Re: 706 Head Gasket Coating
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on April 26, 2005 at 08:11:19 from (66.228.96.252):
In Reply to: Re: 706 Head Gasket Coating posted by dr.sportster on April 26, 2005 at 07:18:19:
I coppercoat all head gaskets I put on,, I dont know,, its like a common practice I do,, The reason is,, on most engines that have not been resurfaced for straightness, usually have a hint of warping in them,, the sealer helps fill in the gaps and keep it sealed a bit better. Coppercoat,, does stay in place, it does help heat transfer to keep the gasket a bit cooler in certain places, when the gaskets get really hot at times,, they loose the seal from expanding, and contracting, old workhorses can use all the preventative maintnence they can get. Some head gaskets you can get lucky and put em on dry, and not leak,, I have seen a few that does, and quite a few trhat I had to do it all over again,,, Chad
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|