Farmall & IHC Tractors Discussion Board |
Re: E85 and an H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on April 13, 2005 at 20:20:33 from (4.224.132.45):
In Reply to: E85 and an H posted by riverbend on April 13, 2005 at 19:54:38:
I use it in all my pulling tractors, which in coincidence, all letter series farmalls. To make it work corectly for your particular engines characterisics, like compression ratio, and jet size in the carb. Compression pressures 100-135psi use a 75% gas and 25% of the E85. 135 to 200 you can make it more of a 60-65% gas 30-35% E85. You will have to rejet the carb, it will use more of it. But, it makes power, kinda an added bonus if you get it right. E85 can sit for a spell,, long as it is sealed, away from water. Will eventually ruin the rubber tip on the needle, if you can find a needle that was steel, you would be fine. Hope this helps,, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|