Farmall & IHC Tractors Discussion Board |
Re: W6 Carb Settings
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by P Backus on April 12, 2005 at 22:53:41 from (66.181.141.7):
In Reply to: W6 Carb Settings posted by Yugrotcart on April 12, 2005 at 15:17:36:
Hey tractor guy!-backwards My I&T manual is a little sparse on the details, so I'll do the best I can. The screw near the bottom of the bowl is the main jet fuel screw. Turning it CW makes the mixture leaner. The screw on the upper part of the carb, but below the throttle plate area is the idle adjusting air screw. Turning it CW makes the mixture richer. The screw on the carb end of the shaft (tube) coming from the governor is the idle speed screw. As far as initial settings, it sticks in my mind that 1 to 1and a half turns out on the screws should get it to run, and then tweak it from there. Maybe someone else knows better. The idle screw can be left alone until it all is running good, then just adjust it until you get a nice idle speed. Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|