Farmall & IHC Tractors Discussion Board |
424 gas governor - what rpm range to kick in?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by blackdog on April 11, 2005 at 15:50:21 from (68.119.108.101):
First of all, let me say that i seem to always do things the hard way. Replaced the old leaky MS carb with a new zenith. The new carb leaked too. Then found out the manifold gasket was bad. Milled the pitted manifold down and put on a new gasket. Adjusted the zenith linkage (while mounted on the engine). The tractor really runs good now (it should after these $$). I am now timid about adjusting the governor. Will i need to wait until heavy load (plow or disc) to know if it needs adjusting?. Thanks, Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|