Farmall & IHC Tractors Discussion Board |
Re: M oilpan gasket!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John M on March 24, 2005 at 07:37:21 from (64.53.74.20):
In Reply to: Re: M oilpan gasket! posted by MagMan on March 24, 2005 at 07:17:43:
the pan and flat surface on the block are fine.The only reason the pan was pulled was to clean the sludge out of the bottom of the pan.It wasnt leaking before I pulled the pan,as I stated it leakes in a different place each time.I have used gasket sealer on the first two and on the second one I didnt just to see if tha twas my problem,then went back and appied it on the last gasket I used.Each time the leak developes in a differnt place.My usual parts guy can only get this "asphaul" looking gasket and my dealer gets on from a different place but its the same.(My dealer isnt the best place for parts,so I tend not to use him).If I cant find one precut then Ill make one,out of cork.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|